The usage of Bricks or Pavers to produce a sidewalk or patio area complements a home in a way that is unrivaled. In addition, installing a Brick or Paver sidewalk does not always need a pro.
The secret to installing a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be installed. The area must be dug out at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines need to be strung on each side of the pathway. The string lines indicate the finished height of the walkway.
When the location has actually been dug down, 3/4" gravel stone should be laid in and tamped down firmly. The height between the tamped down sand and the stringline must equal the density of the brick or paver.
Now that you have a stable base, put a 1" pipeline or journal board the length of the walkway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your pathway border and assistance to keep the integrity and shape of the pathway.
Once this is done, you can then begin to lay the bricks/pavers. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the integrity of the pathway.
Undoubtedly bricks/pavers will require to be cut or split when constructing the pathway. Unless you wish to purchase or lease an expensive wetsaw, I would suggest acquiring a simple brick/paver splitter. It is basically a chisel with a wide end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you wish to break the brick. Then utilizing a hammer strike the butt end of the sculpt strongly. You may require to do this a couple of times. You might likewise wish to flip the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within one or 2 strikes the brick/paver need to break easily. , if your sidewalk has curves you will need to buy/rent a wetsaw.
.
After installing the bricks, develop the outside edges with additional sand, and then shovel in the topsoil and pack down firmly.
Spread stone dust over the new walkway and sweep into the cracks. This will finish the interlocking of the bricks and help to remove any weed growth.
In addition, setting up a Brick or Paver pathway does not necessarily require a pro. The secret to installing a Brick or Paver Walkway is to very read more first properly prepare the location where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipe or ledger board the length of the walkway on either side of the walkway. These strips will act as your walkway border and website assistance to maintain the stability and shape of the pathway. Inevitably bricks/pavers will need to be cut or split when constructing the sidewalk.